GiGi Coconut Honee Flex Wax, 13 OZ

Glyceryl Rosinate, Triethylene Glycol Hydrogenated Rosinate, Beeswax (Cera Alba, Cire D'Abeille), Paraffin, Ethylene/VA Copolymer, Cocos Nucifera (Coconut) Oil, Lanolin, Polyester-3, Silica, Aluminum Hydroxide, Titanium Dioxide (CI 77891)

Instructions for Flex Wax: 1. Place warmer collar around the can of wax by slipping it on from the bottom and moving it to the top of the can, below the lid. 2. Remove plastic lid from wax container and with warmer collar on, place wax container into the wax warmer. Set temperature to High for 35-40 minutes until wax has a caramel like consistency. There should be a small island of unmelted wax in the center of the can with melted wax surrounding it. 3. Once the desired consistency is achieved, lower the setting to "L" low temperature. When wax is not in use, make sure to close the warmer cover. 4. Make sure hands are clean and sanitized by applying GiGi Hand Sanitizer. 5. Cleanse area to be epilated With GiGi Pre Hon cleanser and pat thoroughly dry with tissue. 6. For those extra sensitive to pain, apply GiGi Anesthetic Numbing Spray to a cotton ball/swab then apply to waxing area for 1 minute to temporarily numb the skin. You may also apply directly to skin. 7. Apply a small amount of GiGi Pre Epilation Oil to area to be epilated to protect and prepare the skin for hard wax application. 8. Dip applicator into Flex wax, allowing a ball to form on the end of the applicator. 9. Holding the applicator at a 45° angle, apply a thin layer of wax going against the direction of hair growth then smooth it back over in the opposite direction. Leave a slightly thicker layer of wax at the end of your application to create a pull tab for an easier removal process. (If using near the eye area, instruct client to keep eyes closed).1 0. Press the wax down with your fingertips to ensure the wax has adhered to all the hairs and cools down until it becomes soft and pliable, NOTE: If wax is too thick or left on skin too long it becomes brittle and hard to remove. 11. Flick the extended wax pull tab up, hold the skin taut and pull wax off (parallel to the skin) with one quick motion in the opposite direction of hair growth.
12. Immediately apply firm pressure to epilated area with the cushion of your fingers or palm of your hand to calm the skin. NOTE: Flex Wax can be reapplied up to 2-3 times if necessary.
13. Apply GiGi Wax Off by rubbing gently onto epilated area with fingertips to remove any wax residue and to soothe the skin. Wipe clean with tissue.
14. Apply GiGi Post Epilation Lotion, a rich, moisturizing lotion, to help soften skin and restore moisture.
15. Follow up with GiGi Post Wax Cooling Gel to help soothe irritation and redness.
16. To maintain waxing results longer and minimize the appearance of new hair growth after waxing, smooth on GiGi Slow Grow every day after showering.

NOTE: If wax should fall onto lashes, keep eyes closed. Apply a drop of petroleum jelly on area and remove with an eyebrow comb. Wipe with a moist tissue and then place a cotton swab at the corner of the eye to absorb residue. Warning: external use only. Keep out of reach of children. Caution: Test a small area on the backside of your wrist for temperature sensitivity. Do not use on irritated, cut or broken skin. Do not use inside nose, ears, on nipples, eyelashes, warts and moles or near internal genital area. Do not use if client has varicose veins, diabetes, phlebitis, chapped, sore or sunburned skin, recent scar tissue, eczema or any skin disorder. Do not use if client is using Retin-A, Accutane, Glycolic Acid or Alpha Hydroxy treatment. Client should not use soaps or astringents for 2 hours after application. Advise client to avoid the sun, tanning and hot water for 8 hours before and after any hair removal treatment.