Color Oops Fading Wash

Developer Ingredients: Water (Aqua/Eau), Hydrogen Peroxide, Nonylphenol Ethoxylate, Disodium Phosphate, Amodimethicone, C11-15 Pareth-7, Laureth-9, Glycerin, Trideceth-12, Acrylates / Steareth-20 Methacrylate Crosspolymer, Peg-150/Decyl Alcohol/Smdi Copolymer, Etidronic Acid Bleach Powder Ingredients: Potassium Persulfate, Magnesium Carbonate, Ammonium Persulfate, Sodium Metasilicate, Sodium Stearate, Cyamopsis Tetragonoloba (Guar) Gum, Paraffinum Liquidum/Mineral Oil, Sodium Silicate, Tetrasodium Edta, Sodium Lauryl Sulfate, Sodium Persulfate, Xanthan Gum, Parfum (Fragrance), Carbomer, C.I. 77007 (Ultramarines) Charcoal Shampoo Ingredients: Water (Aqua/Eau), Ammonium Lauryl Sulfate, Cocamidopropyl Betaine, Ammonium Laureth Sulfate, Cocamide Mea, Polyquaternium-7, Ethylhexylglycerin, Phenoxyethanol, Edta, Sodium Hydroxide, Charcoal Powder, Fragrance

PREP BEFORE BLEACHING: For best results hair should be clean and completely dry. Pre-section hair into four sections to help manage bleach application. ONLY apply to areas of hair you wish to fade color. Put on gloves
Put on protective clothing and cover surrounding areas
Open and pour entire contents of the beach powder into the bottle labeled oxide mixing bottle
Replace cap and shake for 30 seconds
Open and pour entire contents of the charcoal shampoo into the mixing bottle
Fill oxide mixing bottle with tap water to the max fill line.
Replace cap, cut tip off oxide mixing bottle while bottle is pointed away from your face
Place gloved finger over the open tip, point away from your face and shake vigorously for 1-2 minutes or until contents are thoroughly mixed.
APPLICATION STEPS: APPLY TO CLEAN DRY HAIR
Immediately after mixing apply to hair saturating and massaging product in
Taking small sections and continue applying fading wash solution through all quadrants
Process for 10 -20 minutes
Rinse with lukewarm water, massaging/lathering product while rinsing
Shampoo and Condition after

See warnings below. Skin Irritation test is recommended before application.
Clean an area the size of a quarter in the bend of your elboz with soap and water, pat dry.
Remove a small amount (approx. 1/2 teaspoon)of color oops bleach powder from the packet and mix with 1.2 teaspoon of charcoal shampoo from the packet and 1/2 teaspoon of color oops oxide in a plastic or glass container.
Apply mixture to skin test area. Let spot dry and do not wash, cover or disturb for 48 hours.
Over the next 48 hours observe your skin and check to see if any redness, irritation, burning, itching or swelling occurs. If so, do not use this product and seek medical attention.
Do Not Leave Mixture contents in Applicator bottle for more than 2 minutes without using contents. Content can build up pressure and bottle may burst, immediately after using product remove nozzle (point away from face), rinse bottle and discard.
Do Not Use metal utensils or tools to mix contents